REFER all servicing to qualified service personnel. UNPLUG this apparatus during lightning storms or when unused for long periods of time. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. USE only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. ONLY USE attachments/accessories specified by the manufacturer. PROTECT the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. The wider blade or the third prong are provided for your safety. 
A grounding type plug has two blades and a third grounding prong. A polarized plug has two blades with one wider than the other.
DO NOT defeat the safety purpose of the polarized or grounding type plug. Do not place any open flame sources on the product. DO NOT install near any heat sources such as open flames, radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Allow sufficient distances for adequate ventilation and install in accordance with the manufacturer’s instructions. DO NOT block any ventilation openings. If you remove or add devices, select Optimize again. Designer optimizes microphone and DSP settings for your equipment combination. Verifying that AEC reference signals are correctly routed. You can customize settings further, but the Optimize workflow gives you a good starting point.Īfter optimizing a room, you should check and adjust settings to fit your needs. The settings are optimized for your particular combination of devices. Enables LED logic control for applicable devices. Creates audio routes and mute control routes. When you select Optimize in a room, Designer does the following: 
Optimize also creates mute control routes in rooms with MXA network mute buttons. Designer's Optimize workflow speeds up the process of connecting systems with at least 1 microphone and 1 audio processor.
0 kommentar(er)
